Build and Shoot

I downloaded openspades 0.0.12b and extracted it and tried to open the program and I get this message without it opening: "The procedure entry point getlogicalprocessorinformation could not be located in the dynamic link library KERNEL32.DLL" once I click ok it closes the message and the same message appears everytime i try to launch it. I can run openspades 0.0.8b without problems and all the opengl stuff is supported. I'm on windows XP also and any help would be nice!

Aragorn3000 wrote:

I downloaded openspades 0.0.12b and extracted it and tried to open the program and I get this message without it opening: "The procedure entry point getlogicalprocessorinformation could not be located in the dynamic link library KERNEL32.DLL" once I click ok it closes the message and the same message appears everytime i try to launch it. I can run openspades 0.0.8b without problems and all the opengl stuff is supported. I'm on windows XP also and any help would be nice!

Microsoft page
You need at least SP3 to use it.

Easier said than done lol, the downloads say it's for it pro's and network installation and to use windows update but using windows update either crashes or leads back to the same download...


P.S. I have sp2 btw

Let's see...
Can you try upgrading Service Packs through any other method?
Is your computer crap? I noticed frame drops from 0.8->0.11 on my PC.
Did you try reinstalling KERNEL32.dll? (It's a pain in the ass though)

Xpert658 wrote:

Did you try reinstalling KERNEL32.dll? (It's a pain in the ass though)

I hope that wasn't serious.

IIRC you can download service pack installation files somewhere from MS and install them like other programs.